 |
|
| Processing Guide: | Silicone |
|
|
| Extruder: | Single screw with attached feeding roll in the intake area. No vacuum required. |
|
|
| Screw Design: |
Single flight screw with diminishing pitch. 10-12:1 L/D. Deep flight transport screw. |
|
|
| Compression Ratio: | typical 1.5 : 1 |
|
|
| Cylinder Temperatures: | Barrel should not exceed 50°C (less in some applications). Cooling water required. |
|
|
| Melt Temperature: | Extruded at room temperature. |
|
|
| Pre-Drying: | Not required. |
|
|
| Calibration: | Not required. |
|
|
| Miscellaneous: |
60-120 mesh stainless steel screen. Extrudate cured by HAV, salt bath or steam. |
